Ace 2+ Pro Step-by-Step Guide

Here's the non-edited version of the Ace 2 Pro set-up video.
https://drive.google.com/file/d/1ruzbiC_DdKZ38wO5njGIr14N-ecSDFLf/view?pli=1

1. Removing the contents from the case. Drone, batteries, wires and controller.

2. Unfolding the drone, showing where the is an SD card slot, removing the camera and gimbal cover, how to charge the controller and batteries and finally how to install the battery.

3. How to download and install the “HUBSAN 3” app to your phone using the QR code in the user manual. Opening the app and agreeing to the user agreements plus giving the app permissions to allow saving of photos and video to your phone.

4. How to turn on the controller using the power button and pressing it twice, holding on the second push for 3 at least seconds until it powers up. How to connect the controller to the phone using the short cable provided. Then finally using the actual app on the phone to finalize the connection to the controller.

5. Connecting the controller to the drone. Power on the drone with the power button, with the double press, as before. The drone is flashing, meaning that it is in connect mode. Once the controller beeps, that means that it is connected to the drone. After that, you can put up the antennas and open up the controller and insert the phone into it. Once you can see through the drone’s camera on the phone, the phone, controller and drone are connected.

6. Next is time to perform the drones geomagnetic and gyro calibrations. This must be done in the exact spot that you intend to fly from, OUTDOORS, where the drone can connect to the GPS satellites. To set the gyro calibration, you press the menu cog at the top right of the app, then press the gyro button and the drone will calibrate the gyros. An on screen message will indicate when that is complete. Then to begin the geomagnetic calibration, in the same menus push the compass calibration button. Then you follow the instructions on the phone and rotate the drone on the horizontal plane clockwise until it beeps. The you rotate the drone, nose down on the vertical plane, again clockwise, until it beeps. Now both the gyro and Geomagnetic calibrations are complete.

7. Next, you put the drone on the ground where you calibrated, and step back about a meter and wait for the drone to find the GPS satellites. You can also see the amount connected on the phone app. Once you get over 10, the drone will unlock and will be safe to fly.

8. To start the drone’s rotors, you can either pull down and out on the controller joysticks, or use the rotor unlock button on the controller. Then you can push up on the left stick to take off, or use the auto take off button in the app. Then you are flying!

Enjoy your flying experience with the Ace 2 Pro drone, and if you do have any questions or need any help, please don’t hesitate to reach out to the customer support team at the Bigly Brothers and we will be most happy to help you.