E59 Mark III Superior Edition Step-by-Step Guide

iOS app link:

Android app link:

To help you get started, we've prepared a straightforward setup guide for you to have a look at. Just follow these steps, and you'll be flying in no time.

Please note this crucial step: The geomagnetic calibration requires a quick press (Step 4), while the gyro calibration needs a press and hold for 3 seconds (Step 7). Failing to perform these steps correctly may prevent the successful completion of the geomagnetic calibration."

1. Unfold the Drone: Remove the drone from its case and carefully unfold all arms until they are fully extended to prevent any unexpected crashes.

2. Power On the Drone: Locate the power button on the drone. Press and hold it for about 3 seconds to turn the drone on, then place it on a flat surface.

3. Activate the Remote Control: Press the power button on the remote control to turn it on. Wait a few seconds for the drone and the remote to connect.

4. Geomagnetic Calibration: Short or Quickly press the geomagnetic calibration button on the remote controller. This is crucial for the drone’s orientation.

5. Horizontal Calibration: Stand facing the drone and slowly rotate it clockwise three times. Listen for a beep from the remote controller, which indicates successful horizontal calibration.

6. Vertical Calibration: Tilt the drone downward and rotate it clockwise three times. The remote controller will beep to confirm successful vertical calibration.

7. Gyro Calibration: Press and hold the gyro calibration button on the remote controller for about 3 seconds. This step is essential to ensure the drone’s stability.

8. GPS Signal Acquisition: Place the drone horizontally, facing you, and step back at least 1 meter. Allow the drone to search for GPS signals for 3-5 minutes. The remote control will emit a beep once a sufficient GPS signal (value of 8 or higher) is detected. If you don’t hear a beep, check the GPS value on the remote controller’s display.

Connecting to the Drone's Application:

Step 1: Prepare the Drone Application

• Locate and scan the QR code provided in the app operating instructions using any QR scanner application. You can download one from your app store (App Store or Google Play Store).
• Alternatively, search and directly install the "RX DRONE" application from your app store.

Step 2: Connect Your Phone to the Drone's Wi-Fi

• Turn off your mobile data to prevent interference during the process.
• Open your phone's Settings.
• Find and select "Wi-Fi."
• Look for the drone's Wi-Fi network name, which usually starts with "HF-GPS5G-XX." This network should be listed among the available networks. If you can't find the drone's Wi-Fi network, try enabling and disabling your phone's Wi-Fi to refresh the network list.

Step 3: Launch the "RX DRONE" Application

• Open the "RX DRONE" application on your phone.
• If prompted, agree to the user agreement and privacy policy.
• When asked, grant the necessary permissions for the application to function properly.
• Inside the application, press the "PLAY" button.
• Wait for the drone's camera image to appear on your phone's screen. Once you see the image from the drone’s camera on your phone’s screen, it indicates that the drone application is successfully connected and ready to use.

Note: If the camera feed does not show after you press the start button, please press the back button and then press the start.