X8 Phoenix Rising GPS Drone Step-by-Step Guide

iOS app link:

Android app link:

Setting up the X8 Phoenix Rising GPS Drone with an Integrated Screen Controller can be an exciting process. Here's a step-by-step guide:

1. Unboxing: Carefully open the package and remove all components. Ensure that all parts are included as per the manual.

2. Charging: Charge the drone's battery using the provided charger. Also, ensure the controller's battery is fully charged.

3. Assembling the Drone: Follow the instruction manual to assemble the drone properly. Typically, this involves attaching propellers, landing gear, and any other components.

4. Controller Setup:
- Power on the controller by pressing the power button.
- Follow the on-screen prompts to set up the controller language, date, and time.
- Make sure the controller is connected to the drone.

5. Powering on the Drone:
- Press the power button on the drone.
- Wait for the drone to initialize. The lights will indicate when it's ready.

6. Controller Pairing:
- Follow the instructions in the manual to pair the controller with the drone. Usually, this involves pressing specific buttons or following on-screen prompts.

7. Calibration:
- Perform a compass calibration by rotating the drone horizontally and vertically as instructed in the manual.
- Calibrate the gyroscopes by placing the drone on a flat surface and following on-screen prompts.

8. GPS Setup:
- Ensure that the GPS signal is strong and stable before takeoff. This usually requires waiting for a few minutes to acquire satellites.

9. Camera Setup:
- Ensure that the memory card is properly inserted into the drone's camera.
- Check camera settings on the controller's screen, adjust resolution, frame rate, etc., as needed.

10. Flight Planning:
- Familiarize yourself with the controller's interface and the pre-installed flight modes.
- Plan your flight route if using GPS waypoints or other advanced features.

11. Pre-flight Checklist:
- Double-check all connections, propellers, and settings.
- Ensure there are no obstacles around for safe takeoff and landing.
- Verify battery levels and signal strength.

12. Takeoff:
- Gently push the throttle stick upwards to take off.
- Maintain control and monitor the drone's behavior during takeoff.

13. Flight:
- Fly the drone within the recommended range and altitude.
- Utilize the obstacle avoidance system if necessary.
- Capture photos or videos using the integrated camera.

14. Landing:
- Bring the drone to a suitable landing spot.
- Slowly reduce throttle to land the drone gently.
- Power off the drone and controller once landed safely.

15. Post-flight Maintenance:
- Inspect the drone for any damage or wear.
- Clean the drone if necessary, especially if it's been exposed to water or snow.
- Store the drone and controller properly for future use.

Following these steps should ensure a smooth setup and enjoyable flying experience with your X8 Phoenix Rising GPS Drone!